...continued from page
3
A Solution Workable In Your Office –
Now
The fact that while a person is standing the
spine is pulled into compensating a position (by the legs
and the largest muscles in the body) and when the person
sits (with the feet flat on the floor in front of him/her),
s/he cannot use the legs or those muscles as effectively,
quickly tells you that a comparison of what happens in the
spine standing versus sitting (which is compensated versus
less compensated) will show you the spine in better and
worse conditions. From that comparison you can figure the
direction of spinal problems and develop a treatment plan
to effectively counteract and correct the problem.
One can get the basic information needed just
measuring and comparing what happens in the pelvis standing
vs. sitting on AP lumbopelvic views without the full spine
films or even with a physical test that does not require
x-rays.
Once you absolutely know the direction of
the person’s primary biomechanical problem, the day-to-day
determination of what should be treated and the direction
of correction can be made by quick and easy physical testing
just before the treatments.
Since the basic research on this has already
been done, Dr. Jutkowitz can teach you a quickly learned
and easy to apply therapy of treating (structural correction)
that is more effective than any other therapy developed
to this point. Though it is not necessary to diagnose and
treat the patient it can be proven on pre- and posttreatment
full spine x-ray if you care to do so.
For chiropractors already knowledgeable and
capable at treating patients mechanically, the first seminar
teaches improvements in basic theory, how to treat, and
a few things not learned in school. The second seminar shows
many pre- and posttreatment films and discusses the changes
and how to make them. Most of the treatments are often already
known by chiropractors, we just clear-up when and how to
employ the knowledge already there and what to abandon as
treatment methods. Those with a good knowledge of chiropractic
can get the information and become competent by doing the
at home learning course. It includes audio and video tapes
and manuals – all the data and specific how-to instructions.
Part two has forty or so actual full spine x-rays with audio
tape explanations demonstrating various findings. There
are also follow-up films discussing the changes you can
expect. Because of the teaching in theory and x-ray analysis,
the at home learning course is recommended for all before
attending the live practical seminars so the time doing
practical work in the seminar can be best utilized.
Within two days of starting the taped seminar,
doctors can more effectively treat patients than ever before.
Practitioners of other healing methods often need more comprehensive
practical drilling to become competent and completely understand
structural healing methods than just the tape course. However,
after examination by a competent practitioner to eliminate
organic cause of disease, the application of these methods
can be competently delivered and the treatment properly
applied after thoroughly drilling the practical methods
until competence is gained in the actual application.
In subsequent seminars practitioners learn
more full spine biomechanics. Many sitting and standing
full spine films are viewed explaining what things change
with what. From this comes an understanding of why one cannot
“push bones directly into their correct position”
to have the patient regain health. The body must be led
through three-dimensional unwinding or untwisting that reverses
the process of injury layered on top of injury. This allows
them to regain their health by going backward through their
sequence of injuries with the chiropractor correcting bones
knocked out of position that the body cannot self correct.
Also taught is how to monitor the process and what supports
to use when.
Leading patients through the unwinding process
(desequencing process) unlocks the Primary Biomechanical
Pathologies (PBPs — the key bones out of place which
hold the body in abnormal patterns). That allows the compensations
to clear, letting the patients heal and get well. This is
the “retracing” of old ills described in natural
healing philosophies. It can be objectively documented on
follow-up x-ray examination and is shown and discussed in
the x-rays that come with the tape series on x-ray analysis.
Now that the research is done full spine x-ray
is optional and not necessary.
Get the Home Seminar/Workshop, start working
Advanced BioStructural Correction™ on your patients.
Then come to a live seminar. Join doctors from all over
the world who are finding answers they thought no one would
ever find in Chiropractic, Osteopathy, or any type of structural
healing. See yourself help patients better then ever before.
You will find answers that lead to much better patient health,
much more personal satisfaction, and much greater practice
growth and income then anything seen before.
Test your current therapy using pre- and posttreatment
sitting and standing full spine x-rays. Tape 14”x17”
cervicothoracic and thoracolumbar films (shoot at 72”)
together if you must, but do them. Most of you will be shocked
by what occurs in the sitting position after some very common
types of treating. Often you will not know whether a change
is good or bad because your old evaluation system doesn’t
have enough data to be able to predict what is a good change
and what is a detrimental change. See the Primer on full
spine x-ray analysis and get the Home Seminar/Workshop so
you can understand the changes.
Dr. Jutkowitz has been measuring sitting
and standing changes for 18 years. He teaches you what the
changes mean and how to keep your patients improving to
the well point.
Credit Cards Accepted
For information on tapes, books, seminars that contain hard
information and not just fluff or to obtain treatment, contact
Dr. Jutkowitz at Advanced BioStructural Correction™
at (203) 366-2746 or Fax us at (305) 422-8251
